Key notes:

T4-XTAX as-built document released. Other XTAX doc ongoing. Drawings of XTAX (2/4/6) to be done in early 2023.
XTAX limitations: SS operation in dump mode not possible with current XTAX for HIKE & SHiP cycles above 1.5E13 ppp (even below this value). Few pulses cases under investigation with more detailed plasticity model.
NA62 will request dump mode operation of 1.2E13 ppp early next year. Reply: Likely to have damage in the bulk material, although device "operationability" may not be compromised looking at experience with T6 XTAX.
Transmission along T4 XTAX system lower than ultimate values. To be discussed further.

ACTION STI → New updates on the limits for new operational regimes. Particularly structural calculations & case with pre-dilution using the T4 target.
ACTION EA/STI → Discuss in early January the status of the functional requirements document. → Milestone: have the doc ready by mid January
ACTION EA/STI → Organize meeting and discuss with Sylvain G. possible inspections on T6 XTAX during the YETS22/23. Ideally inspection of the dumped surface of the 1st Cu block.
ACTION EA/STI → (Yannis) Clarify design of the inserts in T6
ACTION STI → (Luigi/Giuseppe) Discuss transmission results with Gianluigi Arduini.

ACTION EA → Finish and release as-built for TCC8 XTAX
ACTION EA → (less prio) Have new drawings with assembly and inserts (early 2023)
ACTION STI → inform cooling strategies by the ~~end of November~~ early January