Name: IBL Electronics and Module
Start: 2009-02-25T09:00:00+01:00
End: 2009-02-25T13:00:00+01:00
Location: CERN

- 1
  
  Introduction & project organization
  
  Speaker: Giovanni Darbo (Universita degli Studi di Genova Dipart. di Fisica)
  
  Slides
- 2
  
  FE-I4 status and plans
  
  March 2 technical review agenda, plan for final “system oriented” review in ~May, expected submission date
  
  Speaker: Dr Marlon Barbero (Physikalisches Institute, Universitaet Bonn)
  
  Slides
- 3
  
  Stave cable and module options
  
  Pros and cons of cable on top, wrap-around, monolithic bistave. Single chip 3D vs. planar multi-chip modules. Chips up vs down.
  
  Speaker: Dr Marco Oriunno (SLAC National Accelerator Lab (SLAC))
  
  Slides
- 4
  
  Old ROD + new BOC design plans
  
  Re-programming needed to existing ROD, review of what new BOC must do, status of BOC design.
  
  Speaker: Tobias Flick (Bergische Universitaet Wuppertal)
  
  Slides
- 10:45
  
  break
- 5
  
  Updated IBL radiation estimates
  
  Speaker: Ian Dawson (University of Sheffield)
  
  Slides
- 6
  
  Data and TTC transmission baseline
  
  System task force recommendation, 160Mb/s issues & tests needed, modularity, clock multiplication.
  
  Speaker: David John Nelson (Stanford Linear Accelerator Center (SLAC)-Unknown-Unknown)
  
  Slides
- 7
  
  Opto board prototyping plan/needs
  
  What is needed for above baseline. Who can build what when. What about baseline could not work. Alternatives (note extra discussion time)
  
  Speaker: Prof. K.K. Gan (The Ohio State University)
  
  Slides
- 8
  
  DCS and power supplies
  
  DCS and power supply items needed. Production schedule and cost. Availability of parts. Changes needed
  
  Speaker: Susanne Kersten (Fachbereich C / Physik)
  
  Slides

IBL Electronics and Module

40-S2-D01

CERN