Dalia presented the updated status of the project.
Qualitative tests of the calibration method of the bead have been carried out on the DUT.
The preliminary results show a good agreement between measurements and simulations.
Next steps:
1. To complete the main part of the project, more accurate tests must be performed.
Beads must be measured by gauge and then characterized in simulation for the geometry to be verified.
2. Reach the benchmark in the evaluation of the frequency perturbation between measurements and simulations.
3. Preliminary comparison of the measurements between Arduino control and simple DC voltage generator to value the sensibility of the system to a less accurate power source.
4. Analyse the impedance obtained with the bead-pull method from real and virtual measurements and compared with the simulated beam coupling impedance.
5. Definition of the components to be purchased to install a general purpose measurement setup