Status of the Length Measurement at the CTF3 Combiner Ring

→ Europe/Zurich
CERN

CERN

Participants: Daniel, Piotr, Fenu, Yanliang, Tasos, Jakob, Marcin, Tobias, Davide, Andrea, Dario, ?, ?

Daniel reports: rebaselining is OK (we got the required beam energy: 380 GeV), so now we need to recreate a baseline design on these parameters; injectors for instance have to be reviewed because the cost and power consumption of the CDR design was somehow too large.

Dario presents the status of his measurements of the Combiner Ring length at CTF3.

It is important to control the ring length, because it affects the bunch recombination, and the effectiveness of the deceleration process. Wiggler can only lengthen the ring, but Dario tested the impact of quadrupole and dipoles on controlling the ring length also in the shortening direction. He also showed the measuremnt of fractional length differences, through a BPR system. Some systematics appear (one peak is seemingly smaller then the other, in each pairs). Daniel points out that the effect could be simulated to understand it.

Losses play an important role in determining the results. Simulations show a pattern of the losses which depends in the beam energy (depending on the set up of the machine: dipole scaled to lower values, cut higher energies - dopole scaled to larger values cut lower energies). The loss pattern is different in the two cases (faster dacaying for weaker dipoles, slower decaying for stronger dipoles). Further measurements could qualitatively verify if the real losses follow the same behavior.

The systematic scan of quad strengths and dipole strengths shows that the losses impact the measurement, and that the simulations is not too far from reporoducing what happens in the machine. 

In the last plot, it seems that the machine shows a much smaller T566 term than expected (which should be large, as the sextupole magnets are off). In spring some further measurements will be performed. Conclusions are that the setup for the measurement is fucntioning, the simulation with Recirculating PLACET seems qualitatively match the experimental results. Many factors could affect the beam dynamics and justify the discrepancies. Extra data taking sessions could help clarify the inconsistencies.

 

There are minutes attached to this event. Show them.
    • 16:00 → 16:40
      Status of the Length Measurement at the CTF3 Combiner Ring 40m
      Speaker: Dario Pellegrini (Ecole Polytechnique Federale de Lausanne (CH))
      Slides