Speaker
Description
The detection of cosmic rays using simple apparatuses for quantitative data-taking has been explored over the years by several initiatives around the world for outreach and experimental High Energy Physics instrumentation teaching. The possibility to connect geographically dispersed stations synchronized by a GPS timing signal allows for a larger detection area suitable for the identification of high-energy cosmic rays showers. In order for such a system to be deployed in a high school or science museum environment, it must be safe (no flammable gases or high voltages) and low cost, so the network can comprise as many stations as possible. The use of plastic scintillators, SiPMs, and commodity electronic hardware allows the project to fulfill this objective. The readout, timing, and trigger implementation
supports a variety of geometries and even other cosmic rays detection methods
(Cherenkov) that can be easily deployed in the system by a simple reconfiguration
of the hardware.
This enables a variety of experiments to be performed with a single design, thus reducing the complexity and costs of the system construction and operation.
Each station is an autonomous hardware (and firmware) unity that detects cosmic ray events and transmits the data to the software stack through the Internet. These stations are composed of up to four Frontend modules, in which the scintillators, SiPMs, and the analog section of the electronics are located and a Backend module aggregating the trigger, timing, data acquisition, event building, and network communication functions.
The current design is able to use scintillator slabs as thick as 20mm with four 4x4mm² SiPM. The system is sealed in a light-proof aluminum container with two LEDs that can be pulsed in order to provide a light signal for debugging and calibration.
Each Frontend holds a two-channel voltage amplifier followed by a discriminator circuit. Each channel can sum up the signal from two SiPMs or be ganged together to sum the signal from four sensors when a thicker scintillator slab is used. A minimum detection system can comprise only one Frontend module with two separate channels, and detect the passage of cosmic rays by requiring the coincidence of the two signals.
The Backend module is a single board responsible for the trigger, timing, and data acquisition. The power for all the station and network connectivity is also provided through the Backend. Up to four Frontend modules can be connected to a single Backend module through a commodity HDMI cable.
