Optics commissioning and progress with MAD-NG
LNO section meeting on Optics commissioning
Optics commissioning 2023, Andreas Wegscheider, slides
Andreas reports on behalf of the OMC team (optics measurement and correction) on the recent activities in the LHC 2023 commissioning.
A presentation on this subject is also planned in the next LBOC. The focus of the activities were on the optics the changed compared to 2022. The injection optics includes now the phase knob, and non-linear corrections are now used for IP1&5.
The injection optics commissioning was already presented by Ewen in the NDC-LNO meeting on April 5.
The beta-beat was checked throughout the ramp. The maximum peak beta-beat observed remained below 15% such that no extra correction is required.
The beta*=60 cm and 30 cm optics were found to be well corrected with last years corrections requiring no further correction.
The beta-beat at 2m was measured for the “virgin machine” (without global corrections, just local IR corrections) with peak beating up to 25% and using new corrections resulting in a peak beating below 10%. Similar result were also obtained at beta*=1.2 m were the corrected optics maximum beta beat remains within 12%.
The new corrections are trimmed out in the squeeze towards beta* = 60cm.
Measurements of phase and beta beat were also done for the new ion cycle with a squeeze down to 50 cm. Orbit correctors were compared to the settings at 30 cm in the nominal cycle. Applying an energy trim of 0.6e-4 for the ion cycle gave good results as shown in the presentation by Vittorio in the OMC meeting on April 21.
Rogelio comments that it would be a good idea to more generally start optics commissioning by checking the need for energy corrections.
What remains to be done for the ion cycle commissioning are checks with the crossing angle turned on, measurements during the ramp, and optimization of local coupling.
K-modulation measurements in RUN3 , Felix, slides
Felix presents a review of interaction region optics measurements based on K-modulation performed in 2022 and this years optics commissioning. A sinusoidal modulation is applied to selected IR quadrupole strength and the tune changes which are proportional to the beta function (making it more difficult to measure at small beta*) are recorded using the BBQ system. Reliable measurements of beta* require that the waist is well corrected (minimum beta* located a the IP) and local coupling well corrected. For the smaller beta* of 30 cm where a tune uncertainty of 2.5e-5 corresponds to a 10% uncertainty in beta it is important to perform several measurements to check on the reproducibility and to improve the precision by using the averages of multiple measurements.
Stephane asks about the effect of orbit changes induced by K-modulation in the presence of crossing angle bumps.
Felix and Tobias comment that the orbit feedback was used during the K-modulation measurements. It should also be possible to calculate the expected orbit changes by K-modulation in the presence of the crossing angle bumps using MAD.
The beta* values measured by K-modulation were found to agree with the expected values within 1-2%.
In discussions during the meeting it was commented that this can by far not account for luminosity differences reported by the experiments in early 2023 operation with at times 10% less luminosity observed in ATLAS compared to CMS. It has been observed, that the crossing angle in ATLAS appears to be larger than nominal.
Tobias says that the ATLAS crossing angle was trimmed down by 10 μrad today in the LHC.
RP optics status, Stephane
Stephane is working on a new RP flat optics. Hopefully this will be ready by the end of the month and presented along with the task force (Gianluigi) in the LMC. A 2.5 day test after the ion run will be proposed in order to prepare for next year. New hardware needs to be developed for the polarity reversal.
The presentation by Laurent on progress with MAD-NG scheduled for today is postponed to the next LNO meeting, planned in two weeks, after the IPAC23 week.