SLHC Proposal B Meeting: Radiation Damage Studies of OE components

→ Europe/Zurich
Phone meeting - dial CERN operator (CERN)

Phone meeting - dial CERN operator

CERN

Name: Huffman and Issever Date: 21.05.07 Time: 15:00 CERN time Duration: 90 min
Description
A meeting of the radiation damage sub-group within the joint SLHC opto-electronics group. The meeting is to discuss and move forward documentation standarizing the testing of opto-electronic components for use at SLHC fluences. The group has been concentrating so far on the following rad-hard components: optical fibre of all bandwidths, Lasers (both VCSELs and edge-emitting), and PiN diode sensors.
Meeting Agenda
NATO optical test standards
Radiation Test standards for Optical Fibre (v1.1)
Minutes of Group B Optoelectronics Radiation tests Meeting of the opto-radiation standards working group 21/05/07 3pm CERN time. Members Present: F. Vasey, R. Boyd, J. Ye, F. Rizatdinova, K. Gill, K.K. Gan, T. Weidberg Chair: B. T. Huffman Most of the discussion was about the test standards document written by Huffman, Issever, and Weidberg. The ATLAS fibre has a fluorine dopant, some mention of this will be added. A table will be added to include the results from Radiation tests of the CMS and ATLAS optical fibres. K. Gill indicated that the CMS fibre, 100m in length, experienced a 10dB loss when given the lifetime LHC dose in a gamma ray source (I presume it was Co60 Karl?). Exact fibre length specifications to be avoided. Instead estimates of the power budget should determine the length to be exposed. Neutron exposures are difficult to obtain across a wide exposure area, hence it was decided that these would remain as bulk-damage checks once suitable candidate fibres have been identified. A standard power launch down the fibre should be attempted. 100W was the accepted figure. J. Ye mentioned the effect of room temperature annealing. Others should watch for this however all the evidence is that this works in our favour and poses little problems. The effect is likely to be temperature dependent. Fibre should be left in place for measurements even after the exposure for as long as possible. The next meeting will focus on the SEU documentation from J. Ye with a report or even a draft from K.K. Gan and K. Gill on laser test standards (??). That meeting date will be June 7th at 3pm CERN time. I believe C. Issever will be back and will chair the meeting. Minutes by B. T. Huffman
There are minutes attached to this event. Show them.
The agenda of this meeting is empty