Conveners
session 2: Installation & commissioning
- P. Ciriani (TS)
-
Mr J. Sakkinen, S. Prodon (CERN)24/05/2005, 11:10LHC Installation, comissioning and operation from CCCPresentationCe papier présente l’évolution de l’organisation de la logistique de transport pour le projet QRL : d’une logistique basique d’acheminement en position des éléments arrivant au CERN à la gestion d’un stock tampon d’une centaine d’éléments en souterrain et de flux multiples d’alimentation de chantiers de réparation en surface et en souterrain. La philosophie et les modalités de mise en...Go to contribution page
-
Mr Kurt Artoos (CERN)24/05/2005, 11:30LHC Installation, comissioning and operation from CCCPresentationAbout 1800 LHC cryo-magnets will be installed in the LHC tunnel. The transport and installation of the LHC cryo-magnets in the LEP tunnel originally designed for smaller, lighter LEP magnets have required development of completely new handling solutions. The severe space constraints combined with the long, heavy loads meant that solutions had to be very sophisticated. The equipment needed...Go to contribution page
-
Mr J.-M. Chevalley (CERN)24/05/2005, 11:50LHC Installation, comissioning and operation from CCCPresentationLe transport et l’installation de quelque 1800 cryo-aimants dans le tunnel LHC seront réalisés à l’aide d’équipements de transport et de manutention de haute technologie spécialement développés par le groupe TS-IC. La section HM devra assurer la maintenance de toute cette chaîne d’équipements : le pont roulant pour la descente des cryo-aimants dans le tunnel LHC, les véhicules...Go to contribution page
-
Ms C. Bertone (CERN)24/05/2005, 12:10LHC Installation, comissioning and operation from CCCPresentationThe 13 new cold boxes, 5 distribution feed boxes QUI and 8 cryogenic refrigerators QURC necessary to feed LHC with helium, have been installed in the LHC underground areas between May 2003 and June 2005. This paper describes the work over these two years and in particular the design and construction of handling equipment tools, the worksite activities, the operation and finally the...Go to contribution page