IBL Electronics and Module

Europe/Zurich
40-S2-D01 (CERN)

40-S2-D01

CERN

Maurice Garcia-Sciveres (LBNL)
Description
IBL Electronics and Module session of ATLAS upgrade week
    • 1
      Introduction & project organization
      Speaker: Giovanni Darbo (Universita degli Studi di Genova Dipart. di Fisica)
      Slides
    • 2
      FE-I4 status and plans
      March 2 technical review agenda, plan for final “system oriented” review in ~May, expected submission date
      Speaker: Dr Marlon Barbero (Physikalisches Institute, Universitaet Bonn)
      Slides
    • 3
      Stave cable and module options
      Pros and cons of cable on top, wrap-around, monolithic bistave. Single chip 3D vs. planar multi-chip modules. Chips up vs down.
      Speaker: Dr Marco Oriunno (SLAC National Accelerator Lab (SLAC))
      Slides
    • 4
      Old ROD + new BOC design plans
      Re-programming needed to existing ROD, review of what new BOC must do, status of BOC design.
      Speaker: Tobias Flick (Bergische Universitaet Wuppertal)
      Slides
    • 10:45
      break
    • 5
      Updated IBL radiation estimates
      Speaker: Ian Dawson (University of Sheffield)
      Slides
    • 6
      Data and TTC transmission baseline
      System task force recommendation, 160Mb/s issues & tests needed, modularity, clock multiplication.
      Speaker: David John Nelson (Stanford Linear Accelerator Center (SLAC)-Unknown-Unknown)
      Slides
    • 7
      Opto board prototyping plan/needs
      What is needed for above baseline. Who can build what when. What about baseline could not work. Alternatives (note extra discussion time)
      Speaker: Prof. K.K. Gan (The Ohio State University)
      Slides
    • 8
      DCS and power supplies
      DCS and power supply items needed. Production schedule and cost. Availability of parts. Changes needed
      Speaker: Susanne Kersten (Fachbereich C / Physik)
      Slides