PSB Commissioning Meeting #23 (Tune Control with SMWG)

→ Europe/Zurich
774/2-058 (CERN)

774/2-058

CERN

38
Show room on map
Tune control implementation proposal
  • The tune function along the cycle will be defined for each ring and can be different for each beam 
  • The Q-algorithm implemented in in a tune control application (or even directly in LSA) will compute the total strength of the QF and QD based on the Q-algorithm. The makerule in LSA will distribute the current in the various circuits of the quadrupoles (so that the mean K from all rings will go to the common QF and QD trim circuits, and the ring by ring differences will be taken care of by the Q-strips)
  • The tune control application should automatically associate and load the corresponding optics file for each working point along the cycle in LSA
 
Steps:
  • Implementation of a tune control function (To be done by OP)
    • For each tune along the cycle determine the corresponding KFtot and KDtot. Different approaches are available (numerical iteration of the analytical calculation as done in the past, interpolation of a look-up table, interpolation based on optics files uploaded in LSA, …)
    • this function can be either implemented in a tune control application (see below), or directly in LSA as in the past (and in this case would be based on iteration using the analytical model as i n the past)
  • Development of a tune control application (To be done by OP)
    • For each tune along the cycle, this application should load and associate the corresponding optics file into LSA. Linear interpolation between the two closest points in the existing files will be used. 
    • If the tune algorithm is not implemented in LSA, it needs to be implemented in this tune control application (see above)
    • For the first 5ms of the cycle, load the correction functions for the QDE3 and QDE14 for the beta-beat correction during the fall of the chicane. Pre-defined functions for each tune will be provided by ABP based on the simulations initially and on the measurements during commissioning later. The correction functions for the QDE3 and QDE14 should be set to the nominal QDE values after the 5ms. If the Q-algorithm is directly implemented in LSA (see above), this can be done by exploiting the target and correction functionality of LSA. A correction of the main tune functions will then bring the tunes back to the desired values. This aspect can be discussed in a separate meeting.
  • LSA make rule which can handle nested circuits (to be done by CO): 
    • Based on the momentum program and the current in the main circuits (this parameter is fixed) compute the required currents for the Qtrim and Qstrip circuits to reach the target Ks.  
    • Decide how this will be shared between the Qtrim and the Qstrip circuits  
      • Compute the average remaining strength from all the rings --> This will be handled by the Qtrims 
      • Ring-by-ring adjustments using the Qstrips to achieve the target tune function for each ring
    • Conversion from quadrupole strength to actual current to the various quadrupole circuits, based on the calibration curves of each circuit. 
    • Requires the implementation of nested circuits due to the structure of the new main PSB power converter circuits. 
  • Preparation of all the optics files for different working points and define the optimal number of files that are needed for YASP, and possibly for reaching good tune accuracy in case the Q algorithm is based on interpolation of these files (see above). (to be done by ABP) 
  • Preparation of a tool which will automatically upload all the optics files (to be done by CO) 
There are minutes attached to this event. Show them.