LIU-SPS Coordination Meeting

→ Europe/Zurich
Zoom

Zoom

Zoom Meeting ID
97904172722
Host
Kevin Shing Bruce Li
Useful links
Join via phone
Zoom URL

Present: Alexandre Lasheen, Andy Butterworth, Anthony Rey, Antonio Grande Mallavia, Arthur Spierer, Brennan Goddard, Carlo Zannini, Chiara Pasquino, Christine Vollinger, Christos Zamantzas, Danilo Quartullo, David Mcfarlane, David Nisbet, Elena Chapochnikova, Eric Montesinos, Kiki Veyrunes, Etienne Carlier, Fabio Follin, Francesco Maria Velotti, Francois-Xavier Nuiry, Frank Gerigk, Gerd Kotzian, Giovanni Rumolo, Giulia Papotti, Gregoire Hagmann, Hannes Bartosik, Heiko Damerau, Ivan Karpov, Ivan Romera Ramirez , James Ridewood, Johan Dalla-Costa, Johannes Bernhard, Julie Coupard, Kevin Shing Bruce Li, Leandro Intelisano, Loic De Oliveira, Luciana Kolbeck, Maciej Suminski, Marine Gourber-Pace, Michael Schenk, Nico Madysa, Nicolas Magnin, Paul Cruikshank, Philippe Baudrenghien, Reyes Alemany Fernandez, Simon Albright, Stephane Cettour Cave, Tom Levens, Verena Kain, Wolfgang Hofle, Yannick Le Borgne, Zisou Charilaos

Actions

Notes:

  • MKDV should be okay at flat bottom
  • Philippe: ions - HWC was agreed with Reyes, but must be reviewed RF internally; can be attacked once intensity ramp up of protons is fixed;

Hannes:

  • BBA done to avoid using too many correctors at flat top - this to reduce failure modes and as they are not very efficient at flat top
  • Python script prepared that reads ALPS data and computes combined optics response matrix for quadrupole shifts using cpymad; YASP method did not work as expected, so Python script became vital;
  • Very good results obtained after alignment, very consistent with predictions from Python script; vertical bare orbit is good enough such that no correctors are needed on entire cycle of LHCPILOT beam;
  • Changes in orbit when e-cloud or BGI magnets are on;
  • Single iteration found to be sufficient this time!
  • Could we turn the script into a tool? To be discussed --> ACTION: Nico, Michael, Hannes to make a tool of it;
  • Reyes: would you consider to study using orbit correctors in the future in order to avoid having the access; it is still good and you clean up the entire machine and increase the dynamic range, simplifying the setting up;
  • George: slide 4, horizontal alignment counter-acted previous shift, how about the vetrical plane? HB: machine was totally realigned, machine is ; GT: BGI magnets were off during studies;
  • FV: did you check the effect of 

Verena:

  • Method of aperture scans using local bumps and scraping the beam;
  • In 118 aperture of 26 mm where it should be > 45 mm; Chiara and VSC investigated this and found a misalignment of vacuum chambers; this was corrected, now we are at 43 mm; this is still not the full aperture, question is whether this is enough; Francesco had a look at the separatrix and at this location the envelopes very much overlap between injected and slow extracted beam, so the aperture should be enough; proper solution will be implemented during YETS;
  • FV: one needs to pay attention how to compare the numbers from the aperture measurement and the exact location for which Francesco did the evaluation
  • Next step will be to check the aperture in 217

Francesco:

  • Ongoing work, just giving a snapshot
  • Few scans of kicker wave forms done for MKDH and MKDV; scans done changing the injection bucket number; all automatized via script;
  • Tracking with energy looks good;
  • MKDV deflection looks good; MKDH deflection looks too low, this is being investigated;
  • HB: would the eddy currents also apply for the MKDV? FV: normally this should rather be a problem for the MKDH, not so much for the MKDV;

Philippe:

  • LHC and SFTPRO beams ready RF-wise;
  • Minor issues with actions presented; ongoing in parallel;
  • Giulia and Philippe to get in touch for putting together the diagnostics;
  • Hannes: when crossing transition there were transients; we also had missing voltage, we see this also for other beams; would be important to know where we stand with the real voltage, in case we clamp; Greg - we have internal acquisition in firmware - we need to voltage; ACTION: Kevin to get in touch with Greg to send wiki page --> ; Hannes: if you have all phase and voltages, can we not compute voltages and phases in LSA? ACTION: Andy to look into this -- ;
  • Voltage:

Tom:

  • Lots of usage of WS since last meeting; measurement efficiency not very high yet, though;
  • Uncertainty from bunch-to-bunch jitter has been traced back to FW; fix is being deployed --> ;
  • HB: scrubbing will start in 10 days; one of the main goals is to use the wirescanners to take emittance measurements;
  • HB: is the modulation of light intensity understood; this is under investigation but it should not affect the beam size measurement;
  • VK: how are you doing the protection in the end? Nothing changes to run 2; we set up

Athanasios:

  • ALPS interlocking tested; extraction setting up was tested and interlocks are working;
  • Buckets alignment was done; first turn is actually same turn as in FIFO; this needs to be followed up with Friday's update;
  • Fixed ongoing now during access;
  • ACTION: send Verena a list of BPMs that were inverted so that OP can check;
  • Extraction interlock; ideal would be to reduce tolerances to 0.5 mm; from what was seen, this would not work with 0.5 mm, maybe this will get better with multi-bunches; ACTION: include this into tomorrows

RT:

  • LSS1 aperture limitations: at this very location that was analyzed by Francesco we have a current aperture of 37 mm --> we should definitively do something about this in the YETS;
  • Power limitations and cavity conditioning update;

Arising Matters

Round table / AOB 

There are minutes attached to this event. Show them.