28 June 2015 to 2 July 2015
JW Marriott Starr Pass Resort
Etc/GMT-7 timezone

Session

C2PoM - Novel Concepts and New Devices II

C2PoM
30 Jun 2015, 14:00
JW Marriott Starr Pass Resort

JW Marriott Starr Pass Resort

Tucson, Arizona USA

Conveners

C2PoM - Novel Concepts and New Devices II

  • Patrick Adam (Washington State University)
  • QuanSheng Shu (Retired Senior Scientist)

Presentation materials

There are no materials yet.

  1. Prof. SHRIDHAR BAPAT (Department of Mechanical Engineering, Indian Institute of Technology Bombay)
    30/06/2015, 14:00
    CEC-17 - Novel Concepts and New Devices
    Poster Presentation
    Literature suggests that Alpha configuration Stirling cryocooler shows better theoretical performance when compared with Gamma configuration cryocooler. However, this has not been confirmed experimentally due to non-availability of drive mechanism providing large stroke to diameter ratio for Alpha cryocooler. The concept of novel compact drive mechanism can be used to operate miniature Alpha...
    Go to contribution page
  2. Mr Ryosuke Arai (Environment and Energy Materials Division, National Institute for Materials Science)
    30/06/2015, 14:00
    CEC-17 - Novel Concepts and New Devices
    Poster Presentation
    Magnetic refrigeration uses solid magnetic materials as refrigerant without global warming gas and fluorocarbon. In addition, it is expected the higher efficiency than that of vapor refrigeration system. Active Magnetic Regenerative Refrigeration (AMRR) system has demonstrated as an environmentally attractive candidate in near room temperature. There are many studies for the magnetocaloric...
    Go to contribution page
  3. Yannick Bessler (Forschungszentrum Jülich)
    30/06/2015, 14:00
    CEC-17 - Novel Concepts and New Devices
    Poster Presentation
    Neutron scattering experiments benefit from an increasing brilliance of the neutrons supplied. In addition to more powerful neutron sources, the efficiency providing those neutrons is becoming more important. Focus of the report presented here is therefore the optimization of one of the key components, the cold moderator. A cold moderator is usually a pressure vessel, which is filled with...
    Go to contribution page