8-10 June 2016
Asia/Bangkok timezone

The development process of compressed sawdust from fuel rods cool

Not scheduled
15m
Poster presentation Environmental Physics, Atmospheric Physics, Geophysics and Renewable Energy

Speaker

Ms Siriporn Phunphet (Program physics, Fculty of science, Ubon Ratchathani Rajabhat University)

Description

Abstract
The objective of this study was to develop and produce fuel rods from compressed sawdust with the cold. And the thermal efficiency of the fuel rods from sawdust. By testing the efficiency of the fuel rods made from wood sawdust of the third kind See also wainscot wood eucalyptus. And timber The technical feasibility study of the properties of the fuel, the fuel rodsThe heat, humidity, compression ignition timing and temperature of the flame . The fuel rods are made from sawdust and wood species. In this research, the fuel rods use adhesive tag binder is mixed with water in the sawdust of wood species and determine the appropriate ratio to produce fuel rods. The most qualifie, extrusion billet is then compressed by cooling pipes using PVC 2 sizes. The width of the inside diameter of 2 inches and a width of 6 inches outside diameter of the same length is 40 cm. The fuel properties of briquette were analyzed according to ASTM standards. Production of fuel rods from the sawdust with a cold compression process reduces energy use of forest resources in nature. The material can be used in the agricultural and industrial waste to produce renewable energy at a low cost, easy to find ingredients. The conservation of forest resources and nature.
Keywords: sawdust, fuel rods cool,renewable
.

Primary author

Ms Siriporn Phunphet (Program physics, Fculty of science, Ubon Ratchathani Rajabhat University)

Co-author

Dr Thitipong Unchai (Ubon Ratjabhat University)

Presentation materials

There are no materials yet.