CLIC Experimental & Breakdown Studies
Presented: Walter Wuensch, Sergio Calatroni, Iaroslava Profatilova, David Banon Caballero.
Remote connected (via Vidyo): Anton Saressalo, Andreas Kyritsakis from University of Helsinki.
Link to indico page https://indico.cern.ch/event/707855/
Agenda
1. Iaroslava presents “The last results from dark current measurements” from the last 2 months. During this period 007 Hard Cu (60 um gap), 008 Soft Cu (60 um gap), 009 Soft Cu (100 um gap) and old 004 SS Cu electrodes were tested.
The current-voltage diagrams and calculated bettas from Fowler-Nordheim diagrams were shown. Walter mentioned the high values of field enhancement factors, compared to the value taken with tip-plane geometry.
Sergio gave the advice to calculate parameter from F-N equation based on surface area.
The comparison of current densities for these electrodes showed that the highest value has 008 Soft Cu electrodes with 60 mm diameter of the working surface and tested with 60 um gap.
The current more unstable for 008 Soft Cu (similar to 006 Nb electrodes). The measurements were finished with short circuits.
The cameras help to detect the breakdown evens during dark current measurements. The waveforms showed the rapid increase of current during this. The BDs are distributed at all working surface and are not concentrated at “hot spots” or at the edges of electrodes.
Tasks:
- The calculation of betta needs to be checked.
- To calculate the factor at FN equation related to the surface area.
- To improvements for the method of measure CV diagrams and, therefore, betta calculation, need to be done (to measure the current faster, not with long-term measurements).
- During next detection of shirt circuit during measurements, measure the resistance of the system.
2. Anton shortly describes the status of pulsed dc system at Helsinki. The conditioning of Soft Cu electrodes is going.
Next Breakdown studies meeting will be on March, 13.