TWEPP-08 Topical Workshop on Electronics for Particle Physics

Session

Parallel Session B3 - Machine-Experiment, BCM

B3

17 Sept 2008, 11:00

Naxos - GREECE

54. Fast Beam Conditions Monitoring (BCM1F) for CMS.

Mr Vladimir Ryjov (CERN)

17/09/2008, 11:00

Oral

The CMS Beam Conditions and Radiation Monitoring System (BRM) is composed of different subsystems that perform monitoring of, as well as providing the CMS detector protection from, adverse beam conditions inside and around the CMS experiment. This paper presents the Fast Beam Conditions Monitoring subsystem (BCM1F), which is designed for fast flux monitoring based on bunch by bunch...

133. The ATLAS Beam Condition Monitor Commissioning

Dr Andrej Gorisek (J. Stefan Institute, Ljubljana, Slovenia)

17/09/2008, 11:25

Oral

The ATLAS Beam Condition Monitor (BCM) based on radiation hard pCVD diamond sensors and event-by-event measurements of environment close to interaction point (z=+/-184 cm, r=5.5 cm) has been installed in the Pixel detector since early 2008 and together with the Pixel detector in the ATLAS cavern since June 2007. The sensors and front end electronics was shown to withstand 0.5 Mrad and 10^15...

121. The ATLAS Radiation Dose Measurement System and its Extension to SLHC Experiments

Mr Jochen Hartert (University of Freiburg)

17/09/2008, 11:50

Oral

In LHC experiments, a precise measurement of the radiation dose at various detector locations is crucial. In ATLAS, this task is performed by a set of radiation monitors (RADMON) which are able to record Non-Ionising Energy Loss (NIEL), the Total Ionizing Dose (TID) and measure fluences of thermal neutrons. These measurements are vital for understanding the changes in detector performance...