-
Hartmut Sadrozinski (Santa Cruz Inst. for Particle Phys. (SCIPP) - Univ. of Californi)12/11/2007, 11:10Full Detector SystemsWe will show data on C-V, I-V, Cint, Rint etc. pre-rad and post rad. But we will concentrate on charge collection with a beta source and compare neutron irradiated sensors up to 2e15 n/cm^2.Go to contribution page
-
Dr Gianluigi Casse (Department of Physics)12/11/2007, 11:30Full Detector SystemsComparison of the charge collection efficiency of 300µm and 140µm thick silicon microstrip detectors after neutron irradiation up to 1x10^16 cm-2.Go to contribution page
-
Dr Anthony Affolder (University of Liverpool)12/11/2007, 11:50Full Detector SystemsComparison of the charge collection efficiency as a function of resistivity and annealing times for FZ and MCz p-type silicon microstrip detectors after neutron irradiation up to 3x10^15 cm-2.Go to contribution page
-
Panja-Riina Luukka (Helsinki Institute of Physics HIP)12/11/2007, 13:30Full Detector SystemsThe silicon strip detector based beam telescope, the SiBT, was upgraded in spring 2007 using DAQ components from the CMS Tracker module testing and Fermilab D0 RunIIb silicon strip sensors from Hamamatsu. The interpolated position resolution of the telescope is 9 µm, it has a S/N of 25 and an active area of 4 x 4 cm2. The telescope contains 8 reference detector planes in ±45 degree orientation...Go to contribution page
-
Martin Frey (Institut fuer Experimentelle Kernphysik)12/11/2007, 13:50Full Detector SystemsIn a beamtest at CERN H2 the behaviour of irradiated and non-irradiated full-size AC-coupled strip detectors made of n-type magnetic Czochralski silicon was investigated. The sensors of the size of 4x4 cm^2, 300µm thickness with 768 strips and 50µm pitch had been produced at the Helsinki Institute of Physics. After the qualification, the sensors were irradiated with fluences between 10^14/cm^2...Go to contribution page
-
Dr Alberto Messineo (Univ. + INFN)12/11/2007, 14:10Full Detector SystemsPreliminary measurement of CCE on Fz, MCz and Epitaxial micro-strip sensors equipped with CMS F.E. read-out fast electronics.Go to contribution page
-
Dr Lars Eklund (University of Glasgow)12/11/2007, 14:30Full Detector SystemsWe present details of a readout system for strip detectors, using LHCb Beetle chips and TELL1 DAQ. The front-end chip takes analogue samples from each strip at 40MHz. External triggering and time measurement are required to select hits on the sensors. The system has very recently been used at the ATLAS 3D testbeam, with 3D-STC strips (produced by Trento, tested by Freiburg) and with n-on-p...Go to contribution page
-
12/11/2007, 14:50
Choose timezone
Your profile timezone: