Conveners
Mon-Af-Po1.12 - Losses in Conductors and Coils I
- Juan Bascuñàn (MIT)
- Pasquale Fabbricatore (INFN Genova)
-
23/09/2019, 14:30
-
Dr Zhuyong Li (Shanghai Jiao Tong University)23/09/2019, 14:30Poster Presentation
As a novel structure of second-generation high-temperature superconducting (2G HTS) tapes, narrow-stacked HTS wire with 1 mm width was proposed to reduce AC loss. Its fabricated processes are to cut the HTS tapes into 1 mm wide ones mechanically and stack them into one wire through the soldering furnace. In our previous work, compared with the traditional 5 mm wide HTS conductor, the...
Go to contribution page -
Yu Zhang (Huazhong University of Science and Technology)23/09/2019, 14:30Poster Presentation
The HTS windings in magnets can provide large current excitation in a limited space. However, under high level excitation condition, especially in the case of fast adjusting process, AC loss will occur and lead to reduction of thermal stability. The H-formulation method is widely used and basically meets the requirements of AC loss calculation for thousand-turns coil group. However, for...
Go to contribution page -
Mr Jisung Goo (Korea Polytechnic University)23/09/2019, 14:30Poster Presentation
CORC is one of the candidates for high magnetic field and large currents. We are interested in applying CORC to HTS power transformers that require not only large currents but also very low AC losses. We measured and calculated the magnetization losses of short straight CORC samples made of striated YBCO CC. The effect of the striation is certain for reducing the magnetization loss, but the...
Go to contribution page -
Mr Justin Brooks (Robinson Research Institute, Victoria University of Wellington)23/09/2019, 14:30Poster Presentation
Dynamic resistance refers to the emergence of a DC electrical resistance in a superconductor carrying a DC transport current that is exposed to an oscillating AC magnetic field1,2. This phenomenon arises due to the interaction between the transport current and moving fluxons in the superconductor. Quantitatively predicting the magnitude of this effect is important when designing and utilising...
Go to contribution page -
Mr Shuqiang Guo23/09/2019, 14:30Poster Presentation
AC loss is an unavoidable problem for a conduction-cooled HTS SMES magnet during dynamic operation, which may cause a temperature raise and affect the reliable operation of the magnet. In this paper, the 3D-model calculation method of 10MJ- annular magnet is analyzed. And then, the “Dimensionality Reduction-Inversion” method based on H-equation and homogenization modeling method is proposed,...
Go to contribution page -
Takuma Furukawa (Kyushu University)23/09/2019, 14:30Poster Presentation
Our research group have proposed the introduction of transposed parallel conductors which are generally used in conventional electric power machines and devices in order to realize a large current capacity, uniform current sharing and low AC loss. In previous studies, the additional AC loss due to the formation of the parallel conductors composed of two REBa2Cu3Oy (REBCO) superconducting tapes...
Go to contribution page -
23/09/2019, 14:30
-
Xiaoyong Xu (Shanghai Jiao Tong University)23/09/2019, 14:30Poster Presentation
AC loss is an intractable and inevitable issue on high temperature superconducting (HTS) coils and magnets. The HTS coils used in HTS applications will suffer from distorted currents when operate in malfunction. Based on this, AC loss of the double-layer racetrack coil (DRC) carrying harmonic contents in phase or out of phase has been measured with laminated silicon steel sheets (SSS) or not....
Go to contribution page